Audi A4 B7 Rear Brake Caliper Housing Carrier Right O/S 245x10mm 8E0615424G

Audi A4 B7 Rear Brake Caliper Housing Carrier Right O/S 245x10mm is a brake system component designed for installation on the rear right axle of the vehicle. The housing ensures stable positioning of the brake pads relative to the disc, which translates into consistent brake performance and predictable vehicle behavior during braking. This solution is dedicated to drivers who expect consistent rear axle operation after repairs or system upgrades.

Specifications and technical data

• SKU: 8E0615424G
• Mark: Audi
• Condition: Used
• OEM Part Number: 8E0615424G
• Substitutable numbers: 8E0615424G, 8E0 615 424 G
• Location on the vehicle: Rear, Right
• Category: Calipers & Brackets

Purpose and vehicle placement

The presented caliper housing is a component from the Brake calipers and carriers group, designed to operate on the rear right side of the vehicle. This placement requires precise matching of the caliper geometry to the hub, carrier, and disc of a specific thickness and diameter, which allows for maintaining the correct distribution of braking force between the left and right sides of the axle.

Selecting the correct housing for a specific Audi model is crucial for maintaining even pressure of the pads against the disc, and thus for the stability of the car during emergency braking, on wet surfaces, or when driving with a load.

Technical characteristics of the caliper housing

The caliper housing operating with a disc of a specific diameter and thickness has been designed to ensure:

• adequate structural rigidity during intensive braking,
• proper guidance of brake pads in the carrier,
• stable positioning relative to the disc on the rear right axle,
• compatibility with the factory Audi hydraulic system.

Thanks to this, the housing provides a solid base for further assembly (piston, seals, guide pins), allowing for the restoration of consistent brake system operation on the rear right side.

Audi application and installation aspects

The housing is intended for use in Audi vehicles where the rear axle utilizes a disc of the appropriate diameter and thickness. The design is prepared for installation in place of the factory caliper, which facilitates the mechanic's work and limits the need for additional modifications.

When replacing the housing, it is recommended to:

• check the condition of the carrier and guide pins,
• verify disc thickness and brake pad wear,
• bleed the brake system after completing the installation.

This approach allows for fully utilizing the potential of the part and ensuring even operation of the rear axle brakes.

Product condition and benefits of choosing a used housing

The offered item is in used condition, which represents a reasonable compromise between repair costs and maintaining performance parameters similar to factory solutions. Choosing such a housing allows you to:

• reduce the cost of brake system service,
• maintain a design consistent with the original Audi project,
• keep component consistency within one axle.

For many users, this is a practical solution for comprehensive brake maintenance, especially when more than one component on the rear axle is being replaced.

Technical support and additional materials

If you are planning a comprehensive repair or upgrade of the braking zone in your Audi and need other elements from the same group, such as additional housings, carriers, or mounts, check the available parts in the Audi brake calipers and carriers category.

When selecting used brake system components, it is worth following a proven procedure for assessing technical condition. Detailed tips on how to safely choose discs, calipers, and related components can be found in the article: Second-hand brake system: how to safely select discs, calipers, and ABS?