Audi A4 B7 2.0 TFSI Engine Front Axle Driveshaft Left Right N/O/S 8E0407271BE

Audi A4 B7 2.0 TFSI Engine Front Axle Driveshaft Left Right N/O/S is an original drivetrain component from the Driveshafts group, designed for use with a petrol engine and an automatic transmission. Engineered for the front axle, on either the left or right side, it ensures stable torque transmission and proper interaction with the suspension. This solution is dedicated to users who expect a precise fit for the Audi A4 B7 2.0 TFSI specifications.

Specifications and technical data

• SKU: 8E0407271BE
• Mark: Audi
• Condition: Used
• OEM Part Number: 8E0407271BE
• Substitutable numbers: 8E0407271BE, 8E0 407 271 BE
• Location on the vehicle: Front, Left, Right
• Fuel type: Petrol
• Gearbox type: Automatic
• Category: Driveshafts

Purpose and compatibility

The presented front driveshaft has been configured for the Audi A4 B7 2.0 TFSI model, where it works with a petrol unit and an automatic transmission. Its placement on the vehicle includes the front on either the left or right side, allowing for application depending on the specific service needs of the car. By maintaining factory geometry and performance characteristics, this component supports the proper operation of the drivetrain and suspension system.

Technical and functional characteristics

As a part from the Driveshafts group, this driveshaft is responsible for transferring power from the automatic transmission to the front wheels, while simultaneously compensating for suspension movements and wheel steering. The construction adapted to the petrol engine ensures appropriate resistance to dynamic loads typical for TFSI units, as well as proper cooperation with the automatic transmission control system.

Properly selected joints and the length of the driveshaft allow for maintaining correct suspension geometry, which translates into:

• stable vehicle handling during acceleration and braking,
• reduction of vibrations transmitted to the body,
• proper operation of the drivetrain throughout the full range of wheel steering.

Component condition and service application

The product is offered as a used original Audi component, which means it retains factory design and mounting parameters. This is a practical solution in situations where the existing driveshaft has suffered from operational wear, mechanical damage, or if disturbing symptoms have appeared, such as knocking during turns or vibrations during acceleration. Replacing it with an original, used driveshaft allows for an economical repair while maintaining compliance with the manufacturer's design.

Benefits of using an original driveshaft

Using an original front driveshaft in an Audi A4 B7 2.0 TFSI brings a number of service and operational benefits. The most important include:

• factory fitment to the drivetrain and suspension of the specific model,
• maintenance of the correct operating characteristics with the petrol engine and automatic transmission,
• reduction of the risk of installation problems typical of some aftermarket replacements,
• consistency with other drivetrain components.

For workshops and individual users, this means predictable installation and stable operating parameters after the repair.

Selection of drivetrain components and technical knowledge

When replacing a driveshaft, it is worth paying attention to the general condition of the drivetrain – including the clutch, dual-mass flywheel, and cooperating sub-assemblies. A detailed discussion on diagnostics and part selection can be found in the article Clutch and dual-mass flywheel – diagnostics and selection of drivetrain parts, which helps to better plan comprehensive drivetrain maintenance.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your Audi and need other components from the same group, such as additional driveshafts, shafts, or cooperating elements, check the available parts in the Audi Driveshafts category.