Citroen Berlingo Peugeot Partner II 1.6 Hdi Throttle Body Bracket 9662414980

The Citroen Berlingo Peugeot Partner 1.6 Hdi Throttle Body Bracket is an original mounting component from the Clamps and Mounting Parts group, designed for the intake system in vehicles with a 1.6 HDi engine. It stabilizes the position of the throttle body, ensuring secure mounting and proper cooperation with other engine accessory components.

Specifications and technical data

• SKU: 9662414980
• Mark: Citroën
• Condition: Used
• OEM Part Number: 9662414980
• Substitutable numbers: 9662414980
• Category: Brackets & Hardware

Purpose and Function of the Throttle Body Bracket

The throttle body bracket in the Citroen Berlingo and Peugeot Partner with a 1.6 HDi unit is responsible for the rigid, repeatable positioning of the throttle body relative to the intake manifold and engine accessories. A correctly selected component minimizes unwanted vibrations, reduces the risk of stress on pipes and connectors, and helps maintain the seal of connections in the intake system.

Using an original bracket from the Citroën range allows for the preservation of the factory mounting geometry, which translates to stable throttle body operation, correct throttle response, and predictable engine behavior across the full range of loads.

Construction and Mounting Fit

The component is designed as a precision mounting bracket that interfaces with the factory mounting points in the engine bay. Appropriately shaped contact surfaces and prepared locations for screws and clamps facilitate installation and removal, and also reduce the risk of throttle body misalignment.

In practice, this means that with correct selection for a specific version of the Berlingo or Partner, the bracket can be installed in a near plug & play manner, without the need for structural modifications or the fabrication of additional brackets.

Benefits of Using an Original Used Part

Choosing a used throttle body bracket from the Citroën offering is a solution that combines cost control with the preservation of original mounting specifications. Compared to aftermarket alternatives of uncertain origin, an original part ensures:

• factory fit to the intake system and 1.6 HDi engine accessories,
• preservation of the mounting rigidity intended by the manufacturer,
• a lower risk of throttle body mounting geometry issues in the long term.

If you are considering wider use of second-hand parts for your car, it is worth familiarizing yourself with the general principles of selecting such components – the article: check when buying used parts makes the most sense, describes them well.

Service Application and Replacement Scenarios

The throttle body bracket in the Citroen Berlingo and Peugeot Partner is most commonly replaced during:

• mechanical damage resulting from collisions or improper accessory removal,
• cracks or deformations affecting mounting stability,
• comprehensive intake system servicing, when the throttle body and adjacent components are already disassembled.

Selecting the correct bracket for a specific engine and body configuration is crucial for maintaining the correct throttle body position. Therefore, when planning a repair, it is worth verifying the part's compatibility with the vehicle's documentation and existing installation.

Summary

The Citroen Berlingo Peugeot Partner 1.6 Hdi Throttle Body Bracket is a practical, original mounting component from the Clamps and Mounting Parts group that stabilizes the throttle body's position and supports the proper functioning of the intake system. It is a good solution for users looking for a technically matched, used part that allows for the restoration of factory mounting conditions without unnecessary modifications.