BMW E60 E61 LCI 520d N47 Drive Prop Shaft Propshaft Diesel Automatic 7573588

BMW E60 E61 LCI 520d N47 Drive Prop Shaft Propshaft is an original drivetrain component designed for diesel versions with an automatic transmission. It ensures a stable connection between the gearbox and the rear differential, which translates into smooth acceleration and predictable vehicle handling. Thanks to its factory design, the BMW drive shaft maintains the correct operating parameters and geometry of the drivetrain.

Specifications and technical data

• SKU: 7573588
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7573588
• Substitutable numbers: 26107573588, 7573588, 26107565569, 7565569
• Weight: 150
• Fuel type: Diesel
• Gearbox type: Automatic
• Category: Other Transmission & Drivetrain

Purpose and drivetrain compatibility

The presented shaft is dedicated to BMW 5 Series E60 and E61 LCI (facelift) models with the N47 engine and an automatic transmission. It has been designed as a factory component, which facilitates installation in place of a worn-out part without the need for structural modifications. Using the correct shaft in the drivetrain helps to reduce vibrations, noise, and uneven torque transmission.

Design and role in the Cardan Joints system

The shaft belongs to the group of components known as Cardan Joints, responsible for compensating for suspension movements and changes in operating angles between the gearbox and the rear differential. The properly selected length, diameter, and weight of the shaft allow for maintaining the correct balance of the entire system. This reduces the risk of resonance and excessive loads on bearings and joints.

A properly selected drive shaft in a BMW E60/E61 with a diesel engine and automatic transmission contributes to:

• stable torque transmission to the rear axle,
• reduction of vibrations felt in the cabin,
• even operation of joints and supports,
• increased driving comfort at higher speeds.

Condition, origin, and benefits of using a used part

The offered drive shaft is a used part, sourced from a dismantled BMW vehicle. Choosing an original second-hand component is often a beneficial solution compared to replacements of unknown origin, especially in such a critical area as the drivetrain. The factory design ensures compliance with vehicle parameters while allowing for the optimization of repair costs.

The shaft has an assigned OEM number and interchangeable numbers, which facilitates verification of compatibility with a specific car configuration. Before installation, it is recommended to perform a standard inspection of cooperating elements, such as supports, flexible joints, or mounts, to ensure long-term and stable operation of the entire system.

Why it is worth using an original BMW drive shaft

Using an original drive shaft in a BMW E60/E61 520d N47 with an automatic transmission allows you to maintain factory handling characteristics and driving comfort. This component has been designed with a specific fuel type, vehicle weight, and gearbox operating characteristics in mind, which is important under dynamic loads. This solution is particularly recommended when replacing a worn or damaged shaft, when you care about predictable vehicle behavior and reducing the risk of additional vibrations.

If you are preparing your car for the season, a long trip, or want to take a comprehensive approach to inspecting used components, it is worth checking out the practical tips included in the article Winter essentials: which used car parts are worth checking and replacing before the frost?, where you will find checklists and information on selecting components by OEM numbers.

Expansion and service of the BMW Cardan Joints system

If you are planning a comprehensive repair or upgrade of the drivetrain area in your BMW and need other components from the same group, such as intermediate shafts, universal joints, or shaft supports, check out the available parts in the BMW Cardan Joints category.