Audi A4 B7 A5 8T 2.0 TFSI Petrol Throttle Body Motor Valve Flap 06F133062E

Audi A4 B7 A5 8T 2.0 TFSI Petrol Throttle Body Motor Valve Flap is an original intake system component from the Throttle Bodies category, designed for TFSI petrol engines. It ensures precise control over the amount of air supplied to the engine, which translates into stable engine operation, correct throttle response, and proper communication with the vehicle's electronics.

Specifications and technical data

• SKU: 06F133062E
• Mark: Audi
• Condition: Used
• OEM Part Number: 06F133062E
• Substitutable numbers: 06F133062E, 06F 133 062 E
• Fuel type: Petrol
• Category: Throttle Bodies

Purpose and technical function

The throttle body in a petrol engine plays a key role in regulating the airflow into the intake manifold. In TFSI units, it is responsible for:

• precise air metering based on the accelerator pedal position,
• idle speed stabilization,
• cooperation with the engine management system regarding mixture adjustments,
• maintaining proper dynamics during acceleration and downshifting.

A properly selected throttle body for the Audi A4 B7 and Audi A5 8T allows for maintaining factory engine performance, reducing power loss, and eliminating common signs of wear, such as fluctuating idle or delayed throttle response.

Advantages of using an original Audi throttle body

This component, originating from the Audi brand, ensures a design consistent with the vehicle manufacturer's requirements. As a result:

• fitment to the intake manifold and electrical installation is in line with factory standards,
• compatibility with the engine control unit software is maintained,
• there is no need for wiring modifications or mechanical adapters,
• the risk of ECU errors resulting from incorrect operating parameters is minimized.

In the case of TFSI petrol units, using the correct throttle body has a direct impact on engine refinement, fuel consumption, and the proper operation of OBD diagnostic systems.

Operational characteristics and installation

The Audi A4 B7 and A5 8T throttle body has been designed as a component compatible with electronic throttle control (drive-by-wire). This means that after proper installation and adaptation in the engine control unit, it is possible to:

• achieve a smooth, predictable response to accelerator pedal input,
• maintain stable idle speed after the engine warms up,
• ensure proper operation across the full load range – from city driving to highway cruising.

The item from the Throttle Bodies category is structurally prepared for installation in the factory location, which facilitates service work and reduces replacement time. After installation, it is recommended to perform the throttle adaptation procedure using an appropriate diagnostic tester.

Why choose a used OEM component

A used Audi throttle body is a solution that allows you to balance cost control while maintaining performance close to factory specifications. Compared to low-quality aftermarket replacements, the original component:

• is designed for a specific engine type and control unit,
• features a properly matched operating characteristic of the stepper motor / electric actuator,
• maintains compatibility with factory wiring harnesses and connectors.

If you want to better understand when choosing a used component makes the most economic and technical sense, check out our guide: rising repair costs and the boom in used parts – how to save on car maintenance.

Expanding the intake system in your Audi

If you are planning a comprehensive repair or upgrade of the engine area in your Audi and need other elements from the same group, such as additional housings, control elements, or supplementary intake components, check out the available parts in the Audi Throttle Bodies category.